EV Charger Repair & Addition
Level 2 home charging, installed and repaired by the same licensed electricians who work on your solar — so the charger, the panel and the array all get along.
Top Four Reasons EV Chargers Fail
- The Circuit Was Undersized From the StartA charger on a breaker too small for continuous load will trip under a long charge. It is the most common EV charger call we take, and it is an install problem rather than a car problem.
- Nuisance Trips From Shared or Wrongly Protected CircuitsChargers sharing a circuit with other loads, or landed behind the wrong protection, trip for reasons that have nothing to do with a real fault.
- Connector and Cable WearThe handle and cable take a physical beating every day. Pins wear, cables get run over, and the charge rate drops or cuts out intermittently.
- Your Panel Ran Out of RoomOlder Central Texas homes were not built for a 48-amp continuous load. Adding a charger to a full or undersized service panel is where most of these projects actually stall.
Top Four Solutions to This Problem
- Verify the Circuit and the LoadWe measure the actual draw and check the breaker, wire gauge and run length against it. That answers most charger complaints in one visit.
- Correct the Wiring and ProtectionRight breaker, right conductor, right protection, terminations torqued to spec. Trips stop when the circuit matches the load.
- Repair or Replace the Unit ItselfHandles, cables and internal contactors are replaceable. We fix what is fixable and only swap the charger when the unit is genuinely done.
- Add Capacity When You Need ItPanel upgrades, load management and sub-panels, permitted and inspected, so the charger works alongside your solar and battery instead of fighting them.
Let’s get your solar working again.
Book online in under two minutes, or call and talk to someone in Texas.
